...of your products manufactured on M-Konstruktor’s tilting tables.
The ultimate smoothness and flatness (which does not exceed the value of 1.5 mm per 3000 m) of our tables allows you to mould a wide range of flat, non-prestressed products for the housebuilding industry.
Dimensions of the tables shown in the image: 3.75 x 12 m, which also allows you to manufacture longer products, as well as several individual products simultaneously. If the tables are assembled into a single production line, it is possible to get concrete products with a length of up to 36 m, such as piles and non-standard over-sized wall panels.
Concrete mixture consolidation can be performed with the help of surface vibrators or pervibrators. However, to save time and avoid non-consolidated areas on the products, vibrators installed under the table are used. This process is fully automated and is controlled through a control panel. To reduce the impact of vibration on table elements and the foundation, the tables are equipped with damping rubber elements.
The moulding surface is made of a 10 mm thick steel sheet, and the table itself can bear a load of up to 1,000 kg/m²
The advantages of using tilting tables include not only a large range of available products, but also fast cleaning and adjustment times, which is useful in small series production.
The cost of the equipment is determined by several parameters:
To get a quote on tables corresponding to your requirements, please contact our sales office: info@m-konstruktor.ru or leave your request on our website: m-konstruktor.com/steel-moulds-and-concrete-equipment/tilting-tables